4pack 4 Inch Galvanized Iron Dock Cleat,rope Cleat,anchor Line
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613440805
Rough Cast Hot Dipped Galvanized Iron -These are well durable galvanized nautical cleats, 100% protected against rust, ready to use indoor and outdoor.These can hold their own against the weather.Hexagonal Hole for Easy Installation - Bolt will stay in place when securing the cleat. No more holding the bolt with one hand and tightening with the other.(Bolt not included)Wide Footprint for Strength - Large bottom footprint for additional strength,Perfect as cleat hook for boat docks, decks, piers for tying up boats, kayaks and jet ski's.Sturdy Base Ensures Secure Tie Down of your Water CraftHome Nautical Decor- Make your home stand out; perfect for maritime, beach, garden, pool, coastal decorations; use them as cabinet pulls, towel hooks outdoors, rustic coat hanger, curtain tie-backs, nautical coat hooks.Colour:silverMaterial:Malleable steel + hot dip galvanizedSize:About 4 inches long / 103.5mm high 22.5mmPackage Contents:4 * Dock CleatOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.