This item has closed with no items sold
View the relisted Item
View other items offered by Diy Select - Cape Town8005

Similar products

Step Up Boost Converter Lithium 18650 Battery 12V 3A 8W **LOCAL STOCK**
R39.00
Step up Voltage 5V to 12V USB to Male Connector **LOCAL STOCK**
R49.00
Battery 18650 Charger 3S 4A Step Up (3-6V to 12.6V) Type-C **LOCAL STOCK**
R35.00
Battery 18650 Charger 2S 2A Step Up (3-6V to 8.4V) Type-C **LOCAL STOCK**
R35.00
Battery 18650 Step Up UPS Module 5-12V to 12V **LOCAL STOCK**

Battery 18650 Step Up UPS Module 5-12V to 12V **LOCAL STOCK**

3 were available / new
R80.00
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
BAT433
Bob Shop ID
614456096

Step Up UPS Module 5-12V to 12V:

 

Specifications:

Properties: UPS Voltage Converter Module
Working Voltage: 5-12V DC
Output Voltage: 12V DC Default (Unsolder JP1 to change output to 9V)
Output Power: 12W/9W
Support Battery: 3.7V Lithium or polymer battery 15Ah(Max)
Working Temperature Range: -40 to 85
Working Humidity Range: 0%-95% RH
Size: 50 x 20 x 6.3mm


Instructions:

1. Connect right input voltage at input terminal
2. Check output voltage by voltmeter and ammeter
3. Connect battery at B+ and B-

Please note to change from default 12V to 9V output you must unsolder the JP1 connection on the board.
Please note to change from default 0.5A to 1A charging current you must solder the JP2 connection on the board.


Note:

Its max output current is 1A and can not keep output 1A.
The positive and negative poles of the input power supply cannot be reversed Otherwise the module will be damaged.
Users can install a common anode Red-Blue LED by yourself as charging indicators. Blue light indicates whether there is a load at output. Keep Red is charging. There is no battery if Red flashing. Red OFF if charged.
Due to the large current, it is recommended to use a thicker wire. Wire cross-section greater than 1.5 square millimeters.

 
Application:

Ordinary power supply; Battery charger; Mobile power; Power conversion; Infrared alarm; Camera. Network equipment such as switches; Router; Battery car modification

 

 

Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469