Dc 10-55v Motor Speed Controller Module Digital Display 0-100%
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613465574
Intelligent dual mode manual Fully automatic two modes are availableLCD LCD screen with backlight capable of displaying working time speed percentage current mode forward rotation reverse stateSlow start and slow down time can be set with speed upper limit lower limit settingTact switch to switch forward and reverse jog acceleration and deceleration solves the problem of traditional potentiometerCan set working time, time to point stopInput voltage: DC10-55VOutput voltage: linear under loadInstantaneous current: 60Acontinuous current: 40ASpeed control type: adjust currentadjustment speed control mode: jog + -Speed range: 0 - 100%Control frequency: 15KHZWiring type: fence terminal blockSupport motor: brush motorspeed digital display: percentage 0-100Note Input must be divided into positive and negative input voltage should be equal to the rated voltage of the motor (within 10-55V)Motor Type: DC MotorModel Number: CS20color:As shownMaterial:Plastic + MetalPackage Contents:1 x speed controllerOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.