Dc-dc Dc-ac Pure Sine Wave Generator Driver Board (module with Lcd)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613433078
5V single power supply. Pin set up four kinds of pure sine wave output frequency: fixed frequency 50 hz pure sine wave; 60 hz fixed frequency pure sine wave; 0-100 hz pure sine wave frequency is adjustable; 0-400 hz pure sine wave frequency is adjustable.Unipolar and bipolar modulation. Comes with deadband control, pin set up 4 dead time: 300nS dead time; 500nS dead time ; 1.0uS dead time ; 1.5uS dead timeExternal 12MHz crystal oscillator. PWM carrier frequency 23.4KHz. Voltage, current, real time temperature feedback. Overvoltage, undervoltage, overcurrent and overheating protection. Soft-start mode pin setting the response time of 1S.Serial communication to set the output voltage, frequency and other parameters External.External serial port 128 * 32 LCD module 1602 display the voltage, frequency, temperature and electric current of the inverter and other information.Material: Plastic + Metalcolour: As shownPackage Contents:1 x Module with DisplayOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.