Nickel Spot Welder Handheld with Built-in 5V Rechargeable Lithium Battery Pack **LOCAL STOCK**

New
-+
4 available
R725.00
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Free collection from Vasco Estate, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready. Ready for collection by Thursday, 20 June.
Ready to ship in
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Get it now, pay later
Seller
Buyer Protection

Product details

Condition
New
Location
South Africa
Product code
TTL194
Bob Shop ID
615874990

Handheld Spot Welder 5V Rechargeable (Auto or Manual Button Spot Welding):

 

Specifications:

Charging Voltage: 5V DC
Charging Current: 1/2A Max (5V 2A Max Charger Recommended)
Charging Port: USB-C Type Charging Cable


Features:

Handheld All-In-One
Built in 5V Rechargeable Battery Pack
Type-C USB Charger Lead and Nickel strip Included
11 Gear Adjustable Power Display
3 Level Battery Display
Charging Indicator Light

Instruction Manual included

Instructions:

1. The battery should be fully charged, the thickness of the nickel sheet should not be thicker than 0.15mm. At full charge can do 0.2mm
2. Pay attention to the pressure when using the spot welder. The harder you press, the less heat, the lighter you press, the greater the heat. Pressing too light will cause perforation, too heavy and point not firm. So you need the right strength, do not press too hard.
3. The battery you weld on should be polished smooth, remove the surface of any oxide layer and ensure surface is even. If black oxidation occurs on tip of pen, please use fine sandpaper to polish and smooth the tip.
4. Use the most pointed point of the pen. Soldering method: Visually see the welding tip, and the horizontal plane into 60° grip, two needles at the same time pressed in the nickel surface, good contact, current flows from one needle to the other needle, high current melting nickel for a good weld.
Copper, aluminum surface can not be welded, rusty surface can not be welded, smooth stainless steel surface can be welded normally.


Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469

More from this seller

View all
Fuse Holder Panel Mount with Cap **LOCAL STOCK**
R14
LED Cob Light 3V DC Cool White 60x8mm **LOCAL STOCK**
R30
Switch DIP Slide PCB 2Way **LOCAL STOCK**
R3.50
R30 shipping
Controller Over Under Voltage Protection Auto Recovery AC 220V 40A Din Rail **LOCAL STOCK**
R131
Add to cart

Recently viewed

R30 shipping
2 PCS Home Foot Massage Cushion Fitness Toe Pressing Board(Mountain Yellow)
R267

Similar products

Battery Charger Lithium 18650 Mini USB with Protection 5V 1A TP4056 **LOCAL STOCK**
R12.80
R30 shipping
Battery Charge Discharge Start Stop (In: 6-40V) + Display **LOCAL STOCK**
R146
Nickel Spot Welder Copper Rod **LOCAL STOCK**
R75
Battery Charger Lithium 18650 Type-C USB with Protection 5V 1A TP4056 **LOCAL STOCK**
R12.90