L1 Head-up Display Digital Display HUD Speed Water Temperature Voltage OBD + Alarm Monitor For Vehic
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615177737
Description: ???Multi Function Display??? Display of vehicle speed,digital speedometer, water temperature and voltage. ???Alarm Function??? Over-speed alarm, high water temperature alarm, low voltage alarm, gear shift reminder. ???OBD2??? Applicable models: cars with OBD2 interface only.
Specification:
Installation Process: Step 1: when the vehicle is turned off, plug the other end of the OBD cable to the HUD host. Step 2: vehicle ignition starts. Step 3: plug the OBD cable into the car OBD socket.
Note: Please do not operate in the flame-out state, otherwise it may cause the head up display to stay on and consume power!!! Display the mileage after flame-out (because the maximum display value is 199, when the mileage value is greater than 199, it will be counted again,such as the actual 250KM, the display value is 250-199=51).
Package Included:
Specification:
| Material | ABS |
| Colour | black |
| Size | about 80*45*13mm/3.15*1.77*0.51 inch |
| Voltage | OBDII 12V |
| Maximum current | 150Ma |
| Standby current | <20Ma |
| Sleep standby current | <6Ma |
| Operating temperature | -40a??~85a?? |
| Cable length | about 180cm/70.87 inch |
| Weight | about 190g |
| Applicable models | cars with OBD2 interface |
Installation Process: Step 1: when the vehicle is turned off, plug the other end of the OBD cable to the HUD host. Step 2: vehicle ignition starts. Step 3: plug the OBD cable into the car OBD socket.
Note: Please do not operate in the flame-out state, otherwise it may cause the head up display to stay on and consume power!!! Display the mileage after flame-out (because the maximum display value is 199, when the mileage value is greater than 199, it will be counted again,such as the actual 250KM, the display value is 250-199=51).
Package Included:
| 1 X? | HUD Module |
| 1 X? | OBD Line |
| 1 X? | Operation |
| 1X? | Sticker |
| 1 X? | Lens Hood |
| 1 X? | Reflector Film |
