Heatsink Thermal Plaster Glue **LOCAL STOCK**
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Vasco Estate, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 11 June.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
HEA150
Bob Shop ID
614880023
Heat sink Plaster (Thermal Conductive Adhesive) 0.5 Grams:
Specifications:
Thermal Conductivity: >0.671 W/m-k
Thermal Resistance: <0.06 °C-in2/W
Weight: 0.5g
Heatsink adhesive plaster is a thermal conductive paste & adhesive for fixing/gluing 1W-100W led base plate to heatsink.
Instructions:
Apply a very thin layer to the underside of your led. Push firmly down in place on the heatsink allowing excess plaster to escape out around the edge of led. The closer the led is to the heatsink, the better the cooling. Connect your driver and allow the led to shine and create heat to cure the plaster for 10 - 30minutes or until you cannot move the led. (When finished, please cover the tube nozzle with layer of plastic film before turning the cap back to ensure air does not get to the plaster. A small amount of air will solidify the plaster in the tube)
Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469