This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by Diy Select - Cape Town7372

Similar products

Voltage Tester Pen Black 12V-250V AC/DC **LOCAL STOCK**
R39
Battery 12V Low Voltage Alarm and Light **LOCAL STOCK**
R49
Step up Voltage 5V to 12V USB to Male Connector **LOCAL STOCK**
R55
R30 shipping
Dimmer 12V-24V 30A for Led Strip / Voltage Regulator Control **LOCAL STOCK**
R170

Battery 12V Low Voltage Alarm and Light **LOCAL STOCK**

New
R49.00
Closed 9 Jun 24 15:16
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Free collection from Vasco Estate, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready. Ready for collection by Thursday, 20 June.
Ready to ship in
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Get it now, pay later
Buyer Protection

Product details

Condition
New
Location
South Africa
Product code
BAT670
Bob Shop ID
614831674

12V Battery Discharge Alarm & Light:

 

Specifications:

Input Voltage: Under 14V DC
Main Chip: LM358
Size: 29 x 30mm

Used for battery voltage monitoring. When the battery voltage is lower than 10.4 V, the red light will light up and the buzzer alarm will sound, to warn you to disconnect your battery to avoid permanent damage to the battery. You can set the cutoff voltage by adjusting the potentiometer.

Input module with reverse polarity connection protection. But there is no overvoltage protection, if the input is over 14V, it will burn out the chip module.

Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469

More from this seller

View all
Resistor (470 Ohm - 0.25W ) for 1x 5mm Led **LOCAL STOCK**
R0.45
Switch Rocker 15x21mm 3PIN Black 250V 6A On-Off **LOCAL STOCK**
R7.80
Voltmeter Voltage Meter DC 4.5-30V Small 3 Digit Display **LOCAL STOCK**
R38
R30 shipping
Controller Duty Cycle Frequency PWM Digital Display + Knob (1HZ-150kHZ) 3.3-30V **LOCAL STOCK**
R195

Recently viewed

Ic Dip Nor Gate Quad 2-I/P Mc74Ac02N
R13.55