This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1915
Similar products
Double Edge Milling Cutter Engraving Bits Ball Nose End Mills Tool
New
R335.00
Closed
9 Jun 24 23:26
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615192414
Description:
?Double Edge Milling Cutter ?Engraving Bits Ball Nose End Mills Tool
Specifications:
Type:2 flute noze end mills
Material:steel
Color:silver
End design:ball nose
Shank diameter:3.175mm
Cutting edge diameter: 2mm/0.08
Cutting edge length: 17mm/0.67
Total length:approximately 39mm/1.53
Features:
-Non stick knife, tasteless, quiet, blade design, sharp
-Clean, tidy, no burr
-Spiral chip design, chip smooth, reduce heat
-Applies to the relief process of sub GREE, PVC, density board, hard wood
Operation:
1.For the design of portable and desktop woodworking engraving
machine, can not be used in drill machine.
2. Smooth surfaces, such as wood, to avoid the processing of copper,
iron and other metal and sand, stone and other non wood materials.
3. Use appropriate size clip.
4. Tool clamping, found that the knife has a beating phenomenon, should
immediately stop, repeat clip a few times to get the tool shank and fixture
to get full contact, and then work.
5 Cutter handle and the clamping sleeve contact should be good, a tool
shank must be fully inserted into the jacket, tighten firmly.
Package include:
1 x Double edge milling cutter
?Double Edge Milling Cutter ?Engraving Bits Ball Nose End Mills Tool
Specifications:
Type:2 flute noze end mills
Material:steel
Color:silver
End design:ball nose
Shank diameter:3.175mm
Cutting edge diameter: 2mm/0.08
Cutting edge length: 17mm/0.67
Total length:approximately 39mm/1.53
Features:
-Non stick knife, tasteless, quiet, blade design, sharp
-Clean, tidy, no burr
-Spiral chip design, chip smooth, reduce heat
-Applies to the relief process of sub GREE, PVC, density board, hard wood
Operation:
1.For the design of portable and desktop woodworking engraving
machine, can not be used in drill machine.
2. Smooth surfaces, such as wood, to avoid the processing of copper,
iron and other metal and sand, stone and other non wood materials.
3. Use appropriate size clip.
4. Tool clamping, found that the knife has a beating phenomenon, should
immediately stop, repeat clip a few times to get the tool shank and fixture
to get full contact, and then work.
5 Cutter handle and the clamping sleeve contact should be good, a tool
shank must be fully inserted into the jacket, tighten firmly.
Package include:
1 x Double edge milling cutter