This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1886
10pcs 20+4 24pin Power Supply Sync Starter Psu Cable for Gpu Miner
New
R651.00
Closed
22 May 24 15:29
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613484540
Due to the high-power power supply is expensive, with this PSU adapter you can make two small power supply switch at the same time, thus increasing the power supply.Through this adapter you can make two power supply Switch machineat the same time,Assigningthe graphics card power to 2 small power supply instead of thehigh-power power supply.This cable can be used with both 24 pin and 20 pin ATX motherboards.Connection: The main power supply's 24PIN Male andthesecondarypower supply's 24PIN Maleis seperately connected with the PSU's 24Pin Female. and the PSU's 24PIN Male is connected with Motherboard's 24Pin female.Allows you to turn on/off two power supplies simultaneously.Specifications:1 x Male end (Motherboard side): 24pin2 x Female ends (PSU side): 24pinCable length: about 30cmcolour: blackMaterial: PVC+copper wiresPackage Contents:10 x PSU CableOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.