This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1843
6 Pack 3.0-40v to 1.5-35v Power Supply Step Down Module (6 Pack)
New
R314.00
Closed
22 May 24 15:05
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613384694
Input: DC 3 V to 40 V (input voltage must be 1.5 V higher than the output voltage, no boost)Output: DC 1.5 V to 35 V voltage is continuously adjustable, maximum output current is 3 AFeatures: use SANYO solid-state capacitors, 36 u thickening circuit boards, high-Q inductance with LED indicator outputQuantity: 6 piecesSize: 43x21x14mmSteps: connect to power source, adjust the swirl button on the blue potentiometer and monitor voltage with multimeter to get the needed voltage (The factory have tested these at max voltage so they are very high by default, takes about 15-20 turns CCW before the voltage starts ramping down)Notes: The input and output interface can not be reversed. Keep it under 2.5 A and use the heat sink when working for long hours.colour:blueMaterial:ABSPackage Contents:6 x LM2596 Power Supply Step Down ModuleOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.