3pcs bluetooth 4.0 Audio Receiver Module For Stereo Dual Channel Audio Speaker Amplifier JDY-62 Supp
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615102957
Note: Pins can be soldered to pins or patches with 2.54mm pitch and 2.54 pin headers
| Pins | Function | Description |
| 1 | VCC | Voltage range 4.2 to 5V, cana??t exceed?5V |
| 2 | GND | Power GND |
| 3 | L | Left channel output |
| 4 | R | Right channel output |
| 5 | MUTE | High level when mute, usually low level |
| 6 | KC | Empty pin |
Common problem: ? 1. No bluetooth search: Generally caused by power supply interference, the power supply line must be added with LC filter circuit. ? 2. Support 3.7 power supply or not: The module is powered by 5 volts by default. You can replace the upper diode of the JDY-62 module with the 0805 package 0R resistor, or short the wire, so you can use the lithium battery.
3. bluetooth signal is too weak Do not wire or copper under the bluetooth module antenna, or there should be no metal shielding around the antenna. ? 4. The current sound is too loud Generally caused by power ground interference, it is recommended that the power amplifier wiring should not be too long, and the bluetooth ground should be separated from the power ground.
Pakage includes:
3 x Receiver Module?
