ABS Electrical Box Injection Molding Shell of Electric Appliance for Raspberry Pi 4
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615098738
Description: ? Electrical boxes are critical components of your home's electrical system. But for many DIYers, the wide variety of boxes is bewildering. This ABS Electrical Box for Raspberry Pi 4B is made of ABS material, and it has a transparent observation port. The box can be locked by a sliding lock. and it can be hung on the wall through the mounting hole
Features:
? Easy to assemble ABS material Transparent Observation Window Sliding Lock Mounting Hole ? Package included: (the board is not included) ? 1 x ABS Electrical Box? 1 x Single Fan with heat sink 1 x Screw Driver 1 x Aluminum heat sink pack?
How to assemble
? 1. Remove the sliding lock(buckle) and then open the box. 2. Pasting heat sinks and single fan to Raspberry Pi 4B after peeling off the protect film, and then fixed Raspberry Pi 4B PCB to the bottom of the box with screws(Two). 3. Connect the fan's red wire to 5V and Black wire to GND on the Raspberry Pi's GPIO Pin. 4. Close the box and insert the sliding lock and buckle it. 5. Mounting the box to the wall or electrical box.
Features:
? Easy to assemble ABS material Transparent Observation Window Sliding Lock Mounting Hole ? Package included: (the board is not included) ? 1 x ABS Electrical Box? 1 x Single Fan with heat sink 1 x Screw Driver 1 x Aluminum heat sink pack?
How to assemble
? 1. Remove the sliding lock(buckle) and then open the box. 2. Pasting heat sinks and single fan to Raspberry Pi 4B after peeling off the protect film, and then fixed Raspberry Pi 4B PCB to the bottom of the box with screws(Two). 3. Connect the fan's red wire to 5V and Black wire to GND on the Raspberry Pi's GPIO Pin. 4. Close the box and insert the sliding lock and buckle it. 5. Mounting the box to the wall or electrical box.