Nickel Spot Welder Handheld with Built-in 5V Rechargeable Lithium Battery Pack **LOCAL STOCK**
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Vasco Estate, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 28 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
TTL193
Bob Shop ID
613998862
Handheld Spot Welder 5V Rechargeable:
Specifications:
Charging Voltage: 5V DC (Higher than 5V will damage the unit)
Charging Current: 1/2A Max (5V 2A Charger Recommended)
Charging Port: Micro USB Charging Cable
This product supports charging while using
Features:
Handheld All-in-one
Built in 5V Rechargeable Battery Pack
Micro USB Charger Lead and Nickel strip Included
5 Gear Adjustable Power Display
4 Level Battery Display
Charging Indicator Light
Short press to turn on and cycle through power levels, Long press to turn off. 6 min of no use will auto power off
Instructions:
2. Pay attention to the pressure when using the spot welder. The harder you press, the less heat, the lighter you press, the greater the heat. Pressing too light will cause perforation, too heavy and point not firm. So you need the right strength, do not press too hard.
3. The battery you weld on should be polished smooth, remove the surface of any oxide layer and ensure surface is even. Solder pen if oxidation black, please use fine sandpaper polished smooth.
4. Use the most pointed point of the pen. Soldering method: Visually see the welding tip, and the horizontal plane into 60 ° grip, two needles at the same time pressed in the nickel surface, good contact, current flows from one needle to the other needle, high current melting nickel for a good weld. Copper, aluminum surface can not be welded, rusty surface can not be welded, smooth stainless steel surface can be welded normally.
Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469