5V UPS HAT (D) for Raspberry Pi for 21700 batteries
Check my rate
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Product details
Supports Charging And Power Output At The Same Time, With Dynamic Path Management, Stable 5V Output
Comes with online development resources and manual
The UPS HAT (D) is an uninterruptible power supply (UPS) expansion board specially designed for the Raspberry Pi series. Onboard switching Li battery charging chip with path management, boost converter chip, and voltage/current monitoring chip which can monitor the operating state of the batteries via the I2C interface.
- Adopts pogo pins connector design, compatible with Raspberry Pi 3 / 3B+ / 4B, etc.
- Onboard Li battery charging chip, with dynamic path management, more stable power supply
- Onboard boost converter chip for stable 5V power output
- I2C bus communication, monitoring the batteries voltage, current, power, and remaining capacity in real time
- Multi battery protection circuits: over charge/discharge protection, over current protection, short circuit protection, more safe and stable
- Onboard MCU management, supports detecting power connection and booting the Raspberry Pi
- Supports displaying battery level on the system, easy to check the battery remaining capacity
- Onboard LED indicators for monitoring the battery operating status
- Comes with online development resources and manual
| OUTPUT VOLTAGE | 5V |
|---|---|
| CONTROL BUS | I2C |
| BATTERY SUPPORT | 21700 Li battery 2 (in parallel, NOT included) |
| CHARGER SUPPORT | 5V (Type-C port) |
| DIMENSIONS | 56 85mm |
| MOUNTING HOLE SIZE | 3.0mm |
- When connected to the external power supply, the system will be powered and the battery will be charged at the same time, and the battery will be disconnected after being fully charged to avoid battery life damaging caused by frequent charging and discharging
- When the external power supply is insufficient, the battery will provide power output together with the external power supply at the same time to ensure system normal operation
- When the external power supply is connected, the system will keep running normally even when the battery fails or is taken out. And automatically switch over to batteries output if the external power supply is unavailable, keeps the system running without any trouble
Longer Battery Life
Onboard Warning Indicators, Easy To Check If The Battery Is Connected Correctly
Powering The Raspberry Pi Via Pogo Pins, Without Using Any GPIO Resource,
Compatible With Raspberry Pi 3 / 3B+ / 4B, Etc.
Monitoring The Batteries Voltage, Current, Power, And Remaining Capacity Via I2C
When the voltage dips too low, it is possible to save files properly and then shut down the system by software, to avoid any data loss
Detecting Power Connection
Easy To Check The Battery Status In Real-Time, And Automatically Shutdown When The Battery Level Is Low. Onboard MCU Chip For Detecting Power Connection And Automatically Rebooting The Raspberry Pi
Outline Dimensions
What's in the box?
1 x UPS HAT (D)
1 x Acrylic protection panel
1 x Screws pack
You might need to grab some 21700 batteries
Resources
Wiki: http://www.waveshare.com/wiki/UPS_HAT_(D)