This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1908
Similar products
Speaker Power Amplifier Board Dual 15A Relay Protector Boot Delay and DC Detection Protection Module
New
R438.00
Closed
9 Jun 24 23:04
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615103162
Introduction: ? The speaker protection board has a power-on delay (about 3 seconds) and DC protection (about 1V control voltage). With LED status display, it will light when it is protected, and will be extinguished when it is working normally. Adopt 15A high current relay, suitable for most power amplifier boards. The working voltage is 12-15V, which requires independent power supply.
Dimensions: length 65mm width 40mm height 25mm
Note: ? 1. Speaker protection requires independent power supply and cannot share one winding with other circuits. 2. The BTL circuit requires two sets of protection boards (one set of one channel) 3. The protection board is only suitable for dual power supply amplifiers, and cannot be used for single power supply amplifiers.
Package includes:
1 x Speaker protection board
Dimensions: length 65mm width 40mm height 25mm
Note: ? 1. Speaker protection requires independent power supply and cannot share one winding with other circuits. 2. The BTL circuit requires two sets of protection boards (one set of one channel) 3. The protection board is only suitable for dual power supply amplifiers, and cannot be used for single power supply amplifiers.
Package includes:
1 x Speaker protection board