LED SILICONE MOUNTAIN BIKE BICYCLE FRONT & REAR LIGHTS SET
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 10 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Replacementwarranty
Warranty Type: Replacement
Replacement upon receipt (within 7 days of delivery) if wrong item, faulty or broken. Seller pays shipping. Seller may decide to refund if replacement is not available or viable.
Replacement 30 Days
guarantee
Replacement Guarantee:
30 Days: Against mechanical failure when used under normal circumstances - therefore not covering it if failure is due to user abuse such as it being bumped or dropped or if it got wet. Replacement/refund opon return of item in new condition, along with ALL packaging. Seller may decide rather to refund.
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
Bike Frog Light Set
Bob Shop ID
615362969
Description:
- Mode: normally on, burst and flash
- Material: shell silicone inner shell ABS engineering plastic circuit board
- Three lighting modes of water-resistant and drenching proof design
- Multi function fixed mode, 3 seconds quick installation
- Display of installation position: it can be installed at handlebars, cushion risers, front forks, rear upper forks, rear backpacks, shelves, helmets, etc.
- Product Name: Bicycle frog lamp
- Product material: shell silicone inner shell ABS engineering plastic circuit board
- Product colour: black
- Product size: 5 * 3 * 4 cm
- Product weight: 40 g
Directions:
- To connect the LED lamp with the support stand: place the screw in the hole (on support stand), then connect the lamp with the stand using a screwdriver. Once the screw nut is tightened, the device should be good to go!
- please note: the screw may not fit the hole perfectly but should still work.
Included:
- 1 * front (white) warning light
- 1 * rear (red) warning light
I ONLY POST TO ADDRESSES IN SOUTH AFRICA - NO INTERNATIONAL SALES