This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1889
For Argon One M.2 Expansion Board Usb 3.0 to M.2 Sata Ssd Adapter
New
R621.00
Closed
22 May 24 15:28
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613480989
Argon ONE M.2 Expansion Board extends support for M.2 SATA SSDs to maximize the true potential speeds of your Raspberry Pi 4. You will now be able to boot via an M.2 SATA SSD for faster boot times and larger storage capacity compared to the traditional micro-SD Card.To use it, simply replace the bottom of the Argon ONE Case with the expansion board, and the case can now use SSDs. It is recommended to use Raspberry Pi 4 Cases though due to the USB 3.0 ports the boards provide.Argon ONE M.2 is UASP Supported for the Raspberry Pi 4 which means you can maximize the transfer speeds of your M.2 SATA Drive.It is compatible with any M.2 SATA SSD with Key-B and Key B&M. ( not for NVME)colour:blackMaterial:metalPackage Contents:1 x M.2 Expansion Board1 x USB 3.0 Adapter4 x Non-slip gasket4 x ScrewsOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.