Electric Woodworking Carving Chisel Wood Carving Tool Set With 5 Cutter Head And Flexi... (SIZE: #2)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615093544
SELECTED OPTION:
SIZE: #2
Description: Electric Woodworking Carving Chisel Wood Carving Tool Set With 5 Cutter Head And Flexible Shaft For Electric Drill Electric Grinder ?
Specifications: Uses: woodworking Head type: Hex clamping nut Handle material: nylon Overall length: 160mm Flexible Shaft Connection Diameter: 6mm Suitable For: Electric drills, electric grinders.
? #2 1 x Electric chisel 1 x Flexible rubber shaft 5 x Cutter head 1 x Wrench ? Features: In addition to general wood, it is also possible to engrave ebony, soft plastic and so on. The casing is solid, the heat dissipation efficiency is excellent and safe. Mainly used for wood, furniture carving, antique floor carving, potted plants, toys, figures, animals and other sculptures. Each electric chisel is equipped with 5 special cutter heads and a small wrench. The new electric woodworking carving chisel, carving cutter instead of traditional hand-carving, saves time and effort. ? Tips: The electric chisel needs to be equipped with a hanging mill or a small table mill or a drill shaft. The shaft with a soft shaft can be used on a flexible shaft that can be removed. It cannot be used alone, and the motor speed should be less than 12,000 rpm. When using the engraving cutter it must be installed on the right side of the mill or the reverse direction will destroy the flexible shaft. With a 10-point hand, you must stop the 2-3 minute hand to avoid overheating the product. ? Notice: 1.Please allow 1-2mm error due to manual measurement.Please make sure you do not mind before you bid. 2.The colors may have different as the difference display,please understand. ? More Details:
