Cylindrical Display Stand Security System Burglar Alarm / Anti-theft Alarm Display Holder with Infr
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
S-MDC-0621
Bob Shop ID
614995347
Cylindrical Display Stand Security System Burglar Alarm / Anti-theft Alarm Display Holder with Infrared Remote Control for Smartphones with Micro-USB Port
Features
1. Security system is used to secure consumer electronic gadgets in exhibition or store open display against theft. This innovative system is easy to operate and is able to blend easily in any exhibits layout.
2. Charging function: The stand alone security device built in lithium battery, if the power outages that is also with security function. One set of external 5V power adapter, and it can be supply products for charging.
3. Alarming function:
- Contactor alarm: When we pull up the contactor and back of parts VBH adhesive, then it will immediately issued warming sound.
- Cutting cable alarm: When the alarm cable was pulled apart or cut off, then it will immediately issued warming sound.
4. Remote control function: The infrared remote control, anti-interference ability, sensitivity strong.
5. Material: ABS
6. Alarm volume: 95-120dB
7. Input voltage: 110-240V
8. Charging voltage: DC 5V 1A
9. Unlock: Infrared remote control
10. Size: 7.5x5x5cm
Operation Steps
1. The power cable & security stand will connected, and cable line can be go throgh the side groove or bottom.
2. Tear off the bottom sticker, then install it tightly on the clean table(Press time within 10 seconds).
3. Insert the touch sensor cable into the back interface.
4. Tear off the sticker with touch sensor.
5. Paste on the phone back with touch sensor,then it will connected the power adator with security stand.
6. Connect the charging cable with mobile phone, it is successful to install the security stand when you hear a alarm sound.