Waveshare UPS Module Uninterruptible Power Supply 600mAh Li-Po Battery Module Stackable Board for Ra
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
DIY0179
Bob Shop ID
614594509
Waveshare UPS Module Uninterruptible Power Supply 600mAh Li-Po Battery Module Stackable Board for Raspberry Pi Pico
Features
The Pico-UPS-B is a dedicated UPS (Uninterruptible Power Supply) module designed for Raspberry Pi Pico. It incorporates Li-po battery switching charger with power path management, and voltage/current monitoring chip, allows monitoring the battery operating status via I2C bus. What is more, the male pin header make it possible to stack other modules on top.
1. Standard Raspberry Pi Pico header, supports Raspberry Pi Pico series boards
2. Incorporates Li-po battery switching charger with dynamic power path management, more stable power supply
3. I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time
4. Multi battery protection circuits: over charge/discharge protection, over current protection, short circuit protection, and reverse protection, more safe and stable
5. Onboard recharging indicator, power indicator, easy to check the battery status
6. Come with development resources and manual (Raspberry Pi Pico C/C++ and MicroPython examples)
Specification
1. Charging voltage: 5V
2. Control bus: I2C
3. Battery support: 600mAh 3.7V lithium battery
4. Size: 60 x 21mm