Hall Magnetic Induction Sensor Magnetic Detection Magnetic Pole Resolver North and South Pole Detect
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615102705
Product parameters:
Size: 33mm x 22mm
Operating voltage: 4.5V to 24V DC
Module function: South and North poles distinguish, the South Pole is close to the bright blue light, and the North Pole is close to the bright red light.
Maximum output load current: 25MA
Operating temperature range: -40 to 80 degrees Celsius.
Detection distance: visually within 7MM, strong magnetic can reach 1.5CM.
Interface definition:
VCC: Positive power supply
GND: Negative power supply
OUT: output signal
The south pole of the magnet is detected, the blue indicator light is on, and the pin S is outputted low level;
The north pole of the magnet is detected, the red indicator light is on, and the pin N is output low level;
When there is no magnet, the blue and red indicators are off, and the pins S and N are both output high.
Package included:
1 x Hall Magnetic Induction Sensor DIY Kit
Size: 33mm x 22mm
Operating voltage: 4.5V to 24V DC
Module function: South and North poles distinguish, the South Pole is close to the bright blue light, and the North Pole is close to the bright red light.
Maximum output load current: 25MA
Operating temperature range: -40 to 80 degrees Celsius.
Detection distance: visually within 7MM, strong magnetic can reach 1.5CM.
Interface definition:
VCC: Positive power supply
GND: Negative power supply
OUT: output signal
The south pole of the magnet is detected, the blue indicator light is on, and the pin S is outputted low level;
The north pole of the magnet is detected, the red indicator light is on, and the pin N is output low level;
When there is no magnet, the blue and red indicators are off, and the pins S and N are both output high.
Package included:
1 x Hall Magnetic Induction Sensor DIY Kit