Solar Ultrasonic Repeller bird Outdoor Solar Ultrasonic Pest Animal Repeller PIR Repellent Garden Ca

Solar Ultrasonic bird repeller for garden LED flash Mole?Ultrasound dog control fox rodent rats pest?Mosquitoes?animal 120db-Alert

?

3-in-1, Ultrasonic + Strong Light + 120bB Burglar Alarm.

Solar Power & Built-in Ni-MH Rechargeable Battery.

Weather-proof?to work all year-round in all weather conditions .

Once Installation for?permanent service!?

?

INTSRUCTION:

1.?a??ONa???mode: Ultrasonic?+ Strong Light

The Passive ?Infrared?Sensor ( PIR) detects motion and triggers the ultrasonic speaker emitting a tone that people cannot hear but chases away ?common outdoor pests like dogs,?cats,?deer,?raccoons,?mice, skunks,?squirrels and more. Also start the flash Repeller.

2.?a??ALARMa???mode:?Ultrasonic?+?Strong Light + 120bB Burglar Alarm

Infrared sensing head detects moving objects and triggers 120 dB alarm sound and ultrasonic sound and strong light at the same time to?repel?dangerous animals?or evildoer.

3.?a??OFFa???mode: For turn off the repeller

?

Specifications:

Size:?14x11.1x8.7cm (Stand: 32cm)

Weight:?430G

Power?Mode:??Built-n?4x2/3AA Ni-MH rechargeable?Batteries.

Power Consumption?(Working): 15mA

Power Consumption?(Standby):?a???10uA

Ultrasonic Frequency: 25-61KHZ

Alarm?Sound: 120dB ?????????

Coverage Area:?8m /?30ft

?

ASSEMBLING:

1.?Unpack?it?and confirm that?if all?parts ?are present. ?????

2.?It`s?designed?for?continuous?use, with built-in?2/3AA size NI-MH rechargeable?ba?batteries

3.?Once turned ON, the red-LED light and ultrasonic signal will activate for 15 seconds. Among the time , there is sound waves for 2.5 seconds at the beginning. At the same time , the white-LED lights flash blasting. Following this activation,?the unit will?go?to stand-by mode.

4.?The location should allow adequate sunlight?to keep the batteries fully charged.?And make?sure?that?it`s within the effective range of the repeller .

5.?For best results,?please?keep the repeller head roughly9-10 inches above ground.

6.?Take?care?not ?to stress or break the ?repeller when installing in hard ground. It is a good ?idea to prepare the ground for the ground stake to avoid damage to the unit.

7.?When the PIR sensor detects motion, red-LED light will be?on, The ultrasonic signal and the white-LED lights will run for 15 seconds.?Following this, the Repeller will return to stand-by mode.

8.?When the device is working and the PIR sensor detects motion, the Device will run for other 15 seconds in the next time.

?

CAUTION:

a????Check for underground utilities?like?cables or wires before digging or installing?to prevent?personal injury, property damage or even death.

a????Allow the ALARM Repeller to operate continuously for best results.

a????Do not immerse repeller in water.

a????Do not cover-up the PIR sensor.

a????To clean the repeller, use a damp-soft cloth and mild soap with Water. Do not use harsh chemicals or abrasive cleaning agentsThat may damage the repeller.