10pcs 2mm 1/8 Inch Shank Engraving Bit Carbide End Mill Cnc Cutter
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613402572
Use of ultra-fine grain carbide material with good milling, cutting performance, ensure high work efficiency;Have sufficient bending strength and wear resistance; High hardness, high wear resistance, high strength;Sharp cutting edge, milling, hole and plate edge, surface clean, neat, no glitches.End Mill Engraving BitsMaterial: Cemented carbidecolor:gold+silverShank Diameter: 3.175mmCutting Edge Diameter: 2mmOverall Length: 38mmSuitable For:PCB,SMT, CNC, Mould, pastic fiber, carbon fiber, super hard wood, printed circuit board, other precision parts processing.Package included10 x End Mill Engraving BitsOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.