2.8 3.2 Inch TFT/SD Shield Expansion Board For DUE LCD Module SD Card Adapter Geekcreit for Arduino
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612368528
Description: ? 1. TFT LCD in a much faster speed using 84Mhz Ardiuno DUE 2. The shield route all the LCD data pins to port PC1-PC8 and PC12-19, control pins to PD0-PD3,this design can acheive high speed data transfer (three cycles per write strobe to the LCD) to maximize LCD display speed 3. The SPI interface (for SD or flash control) is route to the ISP header of for DUE,so that high speed SPI transfer with DMA can be achieved ? The shield is compatible with for DUE and the following LCD: ? 2.2 TFT LCD module ?(220x176) 2.8 TFT LCD module ?(320x240) 3.2 TFT LCD module with font IC (320x240) 3.2 High resolution TFT LCD module with font IC (480x320) 3.5 TFT LCD module with Font IC (480x320) (Full viewing angle IPS panel) 4.0 TFT LCD module with Font IC (480x320) 4.3 TFT LCD module with Font IC (480x272) 5.0 TFT LCD module with Font IC (800x480) 7.0 TFT LCD module with Font IC (800x480) ? Features: ? 1. Drive TFT LCD on for DUE by just plugging into for DUE main board, no flying wires 2. Compatible with 40-pin version LCD, which is commonly used in TFT DUE shield 3. Also comptabile with 32-pin version LCD, which is commonly used in STM32 development board 4. On board SD card slot with adjustable CS selection 5. On board SPI flash footprint with adjustable CS selection,for upgrade include font IC to draw text to the LCD and also support SPI Flash library 6. LCD power 3.3V and 5V selectable through solder jumpers 7. LCD backlight (LEDA+) 3.3V, 5V or PWM selectable through solder jumpers 8. Pins are routed to reduce CPU cycles, display speed is faster ? Package included: ? 1 X TFT/SD shield expansion board for DUE LCD module
