3pcs 2 Channel 5V DC Relay Module Relay Drive Module Control Board
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612368215
Specifications: ? Supply voltage: 5VDC Current: greater than 100mA Load: 250V 10A AC or 30V 10A DC Dimensions: 50.5mm (length) * 38.5mm (width) * 18.5 (height) Weight: 31g PCB color: black 4 fixing screw holes around the board, hole diameter 3.1mm, easy to install and fix The relay uses high quality Songle relay, single pole double throw. a common end, a normally open end, and a normally closed end Optocoupler isolation, good anti-interference Low level pull-in, high level release. The status indicator is on when the inverter is closed, and the status indicator is off when released. VCC is the system power supply and JD_VCC is the relay power supply. Plug in the jumper cap Relay contact capacity 250V10A. Relay output is normally open, normally closed; Active low. Relay signal input voltage range: 0-5V; VCC system power supply. JD-VCC relay power supply. JD-VCC and VCC are shorted. ? Wiring instructions: ? VCC: system power supply positive GND: system power supply negative IN1--IN2: Relay Control Port (Do not reverse) ? Package Included: ? 3 x 2 Channel 5V DC Relay Module
