40A 2000W PWM DC Motor Controller Reverse Speed Switch Forward and Reverse Moto... (TYPE: BOARDCASE)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612369750
SELECTED OPTION:
TYPE: BOARDCASE
Specifications: ? Input voltage: DC10-50V Output voltage: linear under load Output limit current: 40A (use 20A for a long time, pay attention to keep the module smooth and heat dissipation conditions) Ultimate power: 2000W Speed regulation type: flow regulation Speed regulation method: potentiometer (linear) Speed control duty cycle range: 0-100% Control frequency: 25KHZ Wiring type: Barrier terminal block Knob cord length: 20CM Module size: 110*78*38mm Net product: 245g Motherboard installation size: 100*76*28mm Potentiometer opening according to installation: 7MM ? Note:
Before powering on, make sure that the positive and negative connections are correct. Do not touch the heat sink with the wiring, which may burn the circuit board. Note that this is not a power supply module, it must be connected to the motor to adjust the speed, the output of the multimeter will not change without the motor, and it cannot be connected to AC power.
Package Included:
1 x?40A 2000W PWM DC Motor Controller(you can choose with case or not)
