5-35V Car Auto Rear View Camera Voltage Signal Ballast Ripple Splash Screen Interferenc Power Filter
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CMS6493
Bob Shop ID
614659346
5-35V Car Auto Rear View Camera Voltage Signal Ballast Ripple Splash Screen Interferenc Power Filter
Installation instruction
Output positive and negative power supply connected to the camera, reversing lights power input connector is negative, reversing ballast is the solution to your reversing camera interference ripple best choice
Notice
Some models of German cars and American cars are, after engine start, output voltage interferences, power supply to the reversing lights are not pure DC power supply, but a pulse signal is superimposed on top oscilloscope can be used to test if the conditions will It found a similar square wave signal. Camera power supply line directly on the down lights, because the working voltage is very unstable cause the camera does not work properly, the video signal output is also not normal, so the host can see there is a severe interference, jitter, or not to switch reversing the screen