This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1565
60mm Bench Vice Machine Vise Clamp Full Metal Tools for Diy Table Use
New
R849.00
Closed
22 Apr 24 15:28
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
611160888
LATEST UPGRADE INSTALLATION: The table board up to 2 inch edge of all kinds of desktops. Convenient and quick to install and remove.PROTECT TABLE TOP: During installation, there is no need for punching on the table, with 2 rubber washers to prevent table scratch and 2 jaw washers for protection of the parts (To ensure good use of rubber gaskets, please refer to the product picture before use. Adjust the fixing chin to a larger opening first, then install the rubber washer in the planned corresponding position, secure it in the end).WIDE RANGE OF USES: This vise can hold a variety of parts,O-shape Swivel base allows vise rotating up to 360-Degree, Even if you are left-handed, you can rotate the vise to the position that suits your work.Colour: blueMaterial: metalSize: 60mmPackage Contents:1 * Bench Vice4 * WashersOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.