9 Prong Espresso Distribution Tool WDT
New
Indicative market price: R550
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Bonny Brook, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 7 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 4 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Bob Shop ID:
612622442
9 Prong Espresso Distribution Tool WDT with Holder
Used for declumping coffee grounds for an even bed so you can get a consistent extraction.
9 stainless steel surgical grade needles (0.35mm) and the base is included. It comes fully assembled.
3D Printed to order and made from environmentally friendly and biodegradable plastic. Available in different colours. Please indicate colour at checkout.
This is the same tool designed by JKim and featured by James Hoffmann, Lance Hedrick, JKim, Hoon's Coffee, Brian Quan and others on YouTube.
Youtube features:
- Brian Quan https://www.youtube.com/watch?v=YxRgqz-_BYU
- Lance Hedrick https://www.youtube.com/watch?v=xp3GIR9lynE
- Hoon's Coffee https://www.youtube.com/watch?v=9ph1_gjvD8s
- James Hoffmann https://www.youtube.com/watch?v=X3bEjJ_S2V0
- JKim https://www.youtube.com/watch?v=HMo-2sZ42bY
Note: The tool is printed in high resolution and you're free to paint it any colour you want or polish it yourself. I didn't do any post-processing to the 1 I personally use as I don't think it's necessary (plus it's also a lot of manual labour to do) - it's up to your personal preference.
Pics below are of actual prints:
WDT with optional holder:
Grey:
Blue:
Blue:
Red:
Transparent Blue:
