Acrylic SP GPIO Case for Raspberry Pi 5 active cooler
New
Indicative market price: R140.24
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Henley on Klip, Meyerton
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 14 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
3230
Bob Shop ID:
613929814
Please Note: Raspberry Pi and active cooler are not included
This DIY case requires assembly. You will need a small precision flathead screwdriver.
We also have a fully closed acrylic case available if that suits you more.
Features
What's in the box?
2 x DIY Acrylic Case layers
4 x 5mm standoffs
4 x 18mm standoffs
8 x M2.5x6 screws
4 x rubber feet
Hint
Why are there four extra holes on the bottom plate?
If you buy four 5mm standoffs with M2.5 nuts and M2.5x4 screws, you'll be able to mount an HQ camera on the bottom plate of the case, on which you can then add a tripod. Note: Stock is currently available in South Africa for national shipping!
This DIY case requires assembly. You will need a small precision flathead screwdriver.
We also have a fully closed acrylic case available if that suits you more.
Features
- Two-part Raspberry Pi 5 cover plates
- Easy access to all Pi connectors
- Perfect for use with the official active cooler
- Open design to keep your Raspberry Pi cool
- You can mount a HQ cam onto this case. See the hint at the end of the description
What's in the box?
2 x DIY Acrylic Case layers
4 x 5mm standoffs
4 x 18mm standoffs
8 x M2.5x6 screws
4 x rubber feet
Case Assembly guide
1. Peel the acrylic protective film from the two plates
2. Install the standoffs first. Push the male part of the short standoffs through the RPi board mounting holes from the bottom upwards. Use the Female Female standoffs as nuts on the top of the RPi board.
3. Mount the fan and fan grill on the top acrylic plate.
4. Mount the top and bottom acrylic plates using the eight M2.5x8 screws.
5. Connect your fan power cable to the GPIO port.
Hint
Why are there four extra holes on the bottom plate?
If you buy four 5mm standoffs with M2.5 nuts and M2.5x4 screws, you'll be able to mount an HQ camera on the bottom plate of the case, on which you can then add a tripod. Note: Stock is currently available in South Africa for national shipping!