This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1571
Dc Motor Drive Board 15a 6-36v High-power Industrial Pwm Module
New
R487.00
Closed
22 Apr 24 15:19
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
611120876
The product is industrial-grade design, stable and reliable, with anti-static circuit, transient suppression protection, under-voltage protection, interface ESD and over-voltage protection, etc.;Support a wide range of voltage 9-36V, the maximum continuous load current is 12A (without heat dissipation), 15A (simple heat dissipation), 20A (thick large heat sink);Similar to L298 drive logic, it can control speed regulation, forward and reverse rotation and braking with three wires (PWM, IN1, IN2); Support full PWM, you can directly use the buttons to control the forward and reverse rotation, the effective range of PWM is 0.1%~100.0%;It can provide 5V power supply for microcontrollers and other controllers, and has 5V output overcurrent protection and access signal overvoltage protection.The power supply voltage is 6V-36V (the voltage is too low and the load current is too large to damage the module, so the circuit board is marked as 9-36V), the power supply must not be reversed or exceed 37V, otherwise the module may be burned out, it is recommended to use the power supply A 20A fuse is connected in series at the input end.The rated current of the driver is 12A without heat dissipation. The rated current of 12A~15A needs to be used for simple heat dissipation, and the rated current of 15A~20A needs to be used for thick heat dissipation. (Easy heat dissipation - such as placing a 1mm thermal silica pad under the module and then fixing the module to the device wall with a 5mm copper column)The control signal interface (orange) can provide 5V to the user, and the single-chip microcomputer does not need additional power supply, and the maximum power supply current is 0.5A.Control signal high level voltage: 3.0V~5.5V, compatible with 3.3V and 5V TTL level;Control signal low level voltage: 0V~0.8V, 0V when floating;When the control signal voltage is 5V, the control signal current is 50uA.PWM valid range: 0.1%~100.0%;PWM signal frequency range: 0~100KHz (20KHz recommended);PWM minimum effective pulse width: 200ns.Working temperature -25-80.Product size: 55x55x25mm (length, width and height).Mounting hole diameter: 3mm.Colour: redMaterial: PCBPackage Contents:1 * Motor Drive Board ModuleOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.