HW-M Coil | 0.2 Ohm for Eleaf | 5pcs pack | Generic
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
HW-M-0.2
Bob Shop ID:
612305329
HW-M Coil, 0.2 Ohm, generic vape coil for use with Eleaf.
A cost effective generic for a 'disposable product' (even in its original OEM form).
Coil Specifications
- Brand: Generic (for use with Eleaf)
- Model: HW-M
- Resistance: 0.2 / Ohm
- Range: 40 — 90 Watts
NOTE: Please check your Eleaf unit is suitable to use this coil.
We stock the below range of Generic Eleaf HW-M coils as below:
- HW-M - 0.2 / 40 - 90W
- HW-M - 0.15 / 50 - 100W
TIP's and FAQ's
Limit Leaking coils (all coils OEM or other)
- Apply some super glue to any throw away non-porous surface
- Using a pin or small wire apply glue to the 'O' ring seal on the bottom
- If you get glue on the centre cap (will prevent contact), allow to dry and sand with a nail file
Why does my coil burn?
- A 'dry hit' is an awful taste resulting from your tank liquid been too low. Ensure your tank never runs empty. Even when filing after a 'dry hit' you have reduced the overall lifespan of the coil.
- If you get dry hits with adequate liquid then this due to 'chain vaping'. This means the coil is burning more liquid than it is able to absorb. The only solution is to buy a larger Vape or two of the same or vape less rapidly.
Get a little bit more life out of a used coil
- You can extend the life of 'USED Coils' buy placing them in a small sealed container with Vodka for 2 days and then rinse in pure water (RO or similar with no impurities) for 2 hours.
- Allow to completely dry for a day and enjoy your coils for a little bit longer.
To View our complete Vape Product Range [Click here]
What's in the Box?
1x HW-M Coils - 5pack