This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1566
Mid Motor Gear Sensor for Bafang 3 Pin In One Connector Shift Sensor
New
R664.00
Closed
22 Apr 24 15:25
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
611148267
Type: Gear SensorFunction: Speed Shifter for BAFANG SensorConnector: 3 Pin in One Waterproof ConnectorInstallation Location: Rear DerailleurCompatible: for BAFANG BBS01 BBS02 BBSHDOperating Voltage: 4-5.5 VDCCurrent Consumption: 15ma Gear Sensor for BAFANGSignal Output: Pulse duration 0.5sProtection Circuitz: Short Circuit & Polarity Reversed Protection1. The Gear Sensor acts like a Speed Sensor.2. So you are able to shift your bike at full throttle and barely fill the throttle cut off.3. It will make your BBS02 or BBSHD shift faster, smoother and safer.4. The Gear Sensor is plug and play with any BBS02 or BBSHD in place of one of your e brakes and is a 15 minutes install.5. If you install it with our newest edition of BBS02 or BBSHD the controller has a separate e brake connector so you can use both e brakes and the gear sensor.6. If you go with this setup the shifting power delay is much shorter than using the e brake connector.7. However the gear sensor will work with all for bafang mid drives by simply connecting it to one of the e brake cut off switches. It will also work with any mid drive equipped with an e brake cut off as long as the user can rewire it to fit their e brakes.colour:blackMaterial:ABSPackage Contents:1* one to two brake separation line1* Gear Shift SensorOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.