New 50KHz-200MHz Malahit SDR Receiver Malachite DSP Software Defined Rad... (TYPE: WHITE400MHZ~2GHZ)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612444909
SELECTED OPTION:
TYPE: WHITE400MHZ~2GHZ
for more options in this item.
NOTE:Push the button to EN to boot
Please kindly note before purchase:
1. The software version of this product is 1.10a ?¯??
2. We only sell the hardware, this product does not include follow-up software upgrade service (cannot upgrade to 1.10b).
1. 3.5-inch capacitive screen 2. 4-layer board structure, higher performance than two-layer PCB 3. Adopt a sound unit, 2 vibrating chambers, the speaker comes with a sound chamber, the bass sound quality is very full
Features:
- DSP SDR Receiver for Malahit - Capacitive touch screen - Flash via USB cable - Default frequency range: 50KHz-200MHz,?400MHz~2GHz?(Optional) - Demodulation mode: AM, SSB, NFM, WFM
Product Parameters:
1) The radio is built on the principle of SDR-the function is determined by loaded software; 2)??Frequency range: from 50 kHz to 200 MHz (default version),If you need official firmware, please contact the official website 3) All types of analog modulation: AM, SSB, NFM, WFM; 4) Powerful functions: variable filter width, adaptive noise suppressor, threshold noise suppressor, for Noise Blanker, AGC, equalizer; 5) Use cheap but fully functional chip msi001; 6) The powerful stm32h743 with a clock frequency of 480 MHz is applied; 7) 3.5-inch IPS display touch screen; 8) There is a built-in UHF; 9) Controls: 2pcs; encoders with buttons and touch screen; 10) It is powered by built-in battery and USB, and has linear lithium battery charging management, which can be charged through TYPE-C. The capacity of the built-in battery is not less than 2000mA/h.
11) Consumption: 300mA when listening to headphones; 12) The reception on built-in telescope or external antenna is to improve the HF reception on telescope antenna, and an additional board with source follower has been developed. The board will be built into standard receiver design. 13) Connect to computer via USB, which can transfer CAT, IQ and audio. 14) 160 kHz span, with scalability; 15) Sensitivity: Under the condition of up to 250MHz, s/w is 0.3???V = 10dB; due to lack of measurement equipment, so the above measurements were not taken; 16) Due to the characteristics of msi001 chip used, dynamic blocking range is about 85dB. 17) With backlight control; 18) SMA female antenna socket; 19) Motherboard size: 100 x 70mm (without the sizes of connectors).
Package Included:
- 1 x SDR Receiver - 1 x Antenna
