PGM ZP047 Bench Clamp Fixture Golf Grip Replacement Tool Removal Kit
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
International
Product code:
TBD0604535601
Bob Shop ID:
611360454
1. Rubber grips, no harm to the shaft, stable and non-slip
2. Grip double-sided adhesive, easy to tear and stick firmly
3. Concave round part on the blade, good for trimming burrs
4. Grip removable hook knife, made of tool steel, excellent cutting edge and comfortable grip
5. Golf vise fixture, made of cast steel, sturdy and stable, long service life
6. Weight: ZP047 about 760 g, ZP045 about 60 g, ZP042 about 40 g, ZP044 about 80 g
7. Size: ZP047 about 12 x 13 cm, ZP045 about 8.8 x 2.3 x 2.4 cm, ZP042 about 16.5 cm long, ZP044 about 4.8 x 800 cm
Operating steps:
1. Snap the base of the vise clamp into the bottom of the table, then screw it down to fix it
2. Place the club body into the rubber clamp
3. Place the rubber clamp on the bar into the jaws and rotate it to hold it in place
4. Use the hook knife to scratch along the grip from top to bottom, being careful not to scratch too deeply so as not to injure the pole body
5. Clean the club and apply new grip tape
6. Apply the solvent to the double-sided adhesive, and the grip can be easily pushed in (you need to bring your own solvent)