SA Filament Standard Bed Adhesive 200ml
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 7 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
5229318
Bob Shop ID:
613948852
Standard Bed Adhesive developed by SA Filament for use on PLA and PETG materials on heated beds.
- Minimal smell
- Strong hold from large prints or small contacts on bed
- Easy removal of prints after the bed has cooled down
- Adhesive can be cleaned using water or SA Filament Professional Bed Cleaner
For best results clean bed with Isopropyl alcohol before application to remove any finger marks and dirt
Shake well before use
Spray a single layer on before starting print
Wait for the bed to cool down before removing print
