This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1564
Servo Tester Ccpm Consistency Master Checker 3ch 4.8-6v
New
R304.00
Closed
22 Apr 24 15:02
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
611043486
There are 3 modes to check servos or ESC: Manual mode: turn the knob with different speed, check the reaction time; Neutral mode: make the servo go back to the neutral point;Automatic window wiper mode: make the servo swing like a window wipers in the biggest angle.It can connect 1-3 servos simultaneously and test such as 1-3 servos consistency and so on. You can also connect 1-3 ESC to test and compare their reaction time respectively.It can connect 3 servos of the CCPM helicopters and select servos. It can also connect the servo of airplanes install the steering-box and adjust planes by using such as the neutral mode and so on.CCPM Servo Consistency Master/Servo tester.The device also can be used as a signal generator for electric speed controller (ESC).With it, you can test your motor system without using a transmitter and receiverpackage: 1x testerNote:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.