T8 500mm Lead Screw Set with Shaft Coupling and Mounted Ball Bearing
New
Indicative market price: R548.56
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Henley on Klip, Meyerton
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 14 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
3195
Bob Shop ID:
613700796
These are 4 start 8mm pitch leadscrews with a 200 steps per revolution motor and the 16x microstepping on most common 3D printers. This adds up to 400 steps per mm 3200 steps/ 8mm per rev = 400 steps /mm the same as most 3d Printer lead screws use.
Specifications
Features
What's in the box?
1 x Lead screw
Resources
1. Put screw nut onto the Lead screw. Note: Stock is currently available in South Africa for national shipping!
Specifications
| Lead screw | |
| Material | stainless steel |
| Diameter | 8mm |
Lead | 2mm |
| Total Length | 500mm |
Screw nut | |
| Material: | brass |
| Diameter | 8mm |
Mounted ball bearing | |
| Material | zinc alloy |
| Bore diameter | 5mm |
Hole diameter | 8mm |
| Total length | 55mm |
| Height | 29mm |
Shaft coupling | |
| Material | aluminium |
| Shaft | 6.35mm to 8mm |
| Length | 24mm |
| Diameter | 18mm |
| Quantity | 1 set ( 1 screw 1 Screw nut 2 Mounted ball bearing 1 shaft coupling) |
Features
- Screw mainly used in stepper motors, machine tools, and other CNC equipment.
- Screw directly connected to bearing.
- Suitable for Industrial automation equipment, stepper motor rails, 3D printers, engraving machines, XYZ modules, slider, lifts etc.
What's in the box?
1 x Lead screw
1 x Screw nut
2 x Mounted ball bearings
1 x Shaft coupler
Resources
How to install:
1. Put screw nut onto the Lead screw.
2.Then the 2 Mounted ball bearing separately, install at both ends of the Lead screw.
3. According to the size of you need to adjust the distance between the nut and Mounted ball bearing.
4. Put shaft coupling into the Lead screw beside the Mounted ball bearing.