VERNIER DIGITAL 150MM MEMORY HOLD S/STEEL 0.01MM ACC. METRIC / INCH
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
VS-ME15150
Bob Shop ID:
609002771
Digital vernier caliper
Measuring length: 150mm
Readout: Digital (memory hold)
Material: Stainless steel
Accuracy: 0.05mm
Application:
The vernier caliper is used to give a direct reading of the distance measured with high accuracy and precision.
There are two different vernier calipers available in the Tork Craft range:
- Analog vernier calipers.
- Digital vernier calipers.
Before using a vernier caliper:
- Make sure the workpiece being measuring is clean and has no burrs on the edges.
- Make sure the lathe is switched off when measuring a workpiece in a lathe.
- The temperature of the workpiece is required to be around 20C to have consistent measuring results.
- Precision measuring tools should never be put near a magnetic area to avoid the vernier caliper being magnetized.