This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1836
License Plate Tail Lift Gate Molding for Land Rover Discovery 5 Lr5
New
R1,362.00
Closed
22 May 24 15:33
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613506679
Condition: 100% Brand newFor Land Rover Discovery 5 LR5 2017 2018Decorate your car charming luxury vividINSTRUCTION MANUAL IS NOT INCLUDEDInstallation Tips:1.Pls use alcohol or agent to clean the position of the installation (to make sure it without the grease.Wax or dust etc.)2.pls ensure the position of installation can be completely fit the case before install3.Rive the strong double-sided adhesive of the back , if meet the case of a relatively low temperature, please heating it via the hair dryer or lighter .4.According to the comparison stick up it and press about 1-2 minutes (Note:do not wash your car in 24hours , the adhesive should be fixed after 12 hours )5.The installation have been completed , DIY item --- Easy to installcolor:BlackMaterial:plasticPackage Contents:1 x Rear License Plate MoldingOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.