Waveshare 8-channel 5V Relay Module Expansion Board with Optocoupler Isolation Support for Jetson
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615107094
Documents:
Overview:
The RPi Relay Board (B) is an expansion board with 8-ch relays. It gives your Pi the ability to control high voltage products such as home appliances.
Features:
Standard Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano High quality relays, loads up to 5A 250V AC or 5A 30V DC Photo coupling isolation, prevent interference from high voltage circuit Standard rail mount bottom case Onboard LEDs for indicating relays status Relay control pin selection jumper, allows to control the relays by custom pins other than the default pins Reserved control Interface, allows to work with controllers like PLC
Specifications:
Power supply voltage: 5V Trigger signal: 3.3V/5V Relay channels: 8-ch Contact form: SPDT-NO,NC Closed current: 6mA (per channel) Connector: screw terminal block Dimension: 232 ?? 72 (mm) Mounting hole size: 3.0mm
Package includes:
1 x RPi Relay Board (B) 1 x Rail housing 1 x Screw pack
Overview:
The RPi Relay Board (B) is an expansion board with 8-ch relays. It gives your Pi the ability to control high voltage products such as home appliances.
Features:
Standard Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano High quality relays, loads up to 5A 250V AC or 5A 30V DC Photo coupling isolation, prevent interference from high voltage circuit Standard rail mount bottom case Onboard LEDs for indicating relays status Relay control pin selection jumper, allows to control the relays by custom pins other than the default pins Reserved control Interface, allows to work with controllers like PLC
Specifications:
Power supply voltage: 5V Trigger signal: 3.3V/5V Relay channels: 8-ch Contact form: SPDT-NO,NC Closed current: 6mA (per channel) Connector: screw terminal block Dimension: 232 ?? 72 (mm) Mounting hole size: 3.0mm
Package includes:
1 x RPi Relay Board (B) 1 x Rail housing 1 x Screw pack
