This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1797
Noise Reduction Condenser Microphone Kit for Studio Live Broadcast
New
R482.00
Closed
22 May 24 15:21
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613454314
Diamond edge design with built-in anti-vibration device to reduce structural noise.Higher sensitivity, less noise, faster response, brighter sound.Support all kinds of mainstream sound cards, condenser microphones, instant response / full low frequency / powerful mid-range / transparent high.Microphone type: capacitive, externally polarizedInternal impedance: 100Energy exchange principle: pressure gradient sensorRated load impedance: 1000Sound head diameter: 25mmPower supply voltage: 5VDirectivity: heart shapeRated current: 3.1maSensitivity: 16.7mv/pa-35.5 dbv / PAEquivalent noise level: 19dB (a)Interface: Gold Plated 3-pin XLRMaximum sound pressure level: 142db, 0dB pre attenuationDynamic range 123dB (a)Colour: blackMaterial: plasticSize: 13.7x5.2x3.6cmPackage Contents:1 * Microphone1 * 2.5m 6.0 audio cableOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.