This item has closed with no items sold
View other items offered by PC Spot350
Buffing pad medium 150mm to fit 12.5mm arbor/spindle - white
New
R219.00
Closed
21 May 24 00:33
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
VS-TC872100
Bob Shop ID
615686051
Buffing pad
Buffing pad density: Medium
Diameter: 150mm
Bore: 12.5mm
Application:
The buffing pad is used together with a chuck adaptor spindle supplied with theTC874 polishing kits.
Alternatively theTC336 arbor would also fit the buffing pad.
How to use the compounds and the buffing pads:
- The adaptor is used to hold the buffing pad in the drill's chuck. Fasten the correct buffing pad in the adaptor. Make sure the flanges are on both sides of the buffing pad.
- It would be best to use a drill press to polish metals. If a drill press is not accessible, use adaptor TCV01810 with a portable drill with a collar diameter of 43mm. Tighten the adaptor in the drill's chuck.
- The buffing pad should revolve towards you at full speed. Pass the compound lightly across the face of the buffing pad. To ensure that the compound is evenly spread, hold a clean piece of scrap metal against the face of the buffing pad. This will eliminate lumps of compound from occurring.
- If desired, heat the item to 65C using an oven or a heater. Warming the metal keeps the compound on the buffing pad. A cool item will draw compound from the pad and leave deposits. Use a glove to handle the warm item.
- Hold the metal lightly against the buffing pad. Allow the compound to do the work.
- If more compound is required, apply it using a wiping motion. Do not overload the buffing pad.
Use Tork Craft's line of buffing pads and compounds to clean, polish and bring to a high gloss, all metals and plastics.
| HEAVY DUTY CLEANING | REGULAR CLEANING | LIGHT POLISHING | HIGH GLOSS POLISHING | |
| Hard metals | 1 | 2 | 5 | 6 |
| Soft metals | 3 | 5 | 6 | |
| Precious metals | 4 | 5 | 6 |