USB Duplex MMDVM Hotspot+Raspberry Pi zero+2pcs Antenna+3.2 LCD+Protetive Case+8G... (COLOR.: BLACK)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615100753
SELECTED OPTION:
COLOR.: BLACK
- USB port design
- High performance 32-bit ARM processor
- Fully tested
- Supports DMR, P-25,D-Star and System Fusion
- Onboard LEDs to show status (Tx,Rx,PTT,Mode)
- Up to 10mW RF power
- SMA antenna connector,Antenna included
- Mounts cleanly on all current Raspberry-Pi's including the Pi?0(zero)
- The firmware is pre-loaded and is easily upgraded via software.
- Open source 3D printable case available
- Uhf 430-450 MHz,433mhz and 900MHz
VHF 144 220 Opera FREQ
Install the firmware with bootloader support for USB connection
If you want to use the device via USB port you have to install a bootloader and build the firmware with bootloader support. As the raw device cannot be used with USB you have to use a USB-serial adapter or STlink device
The upper part?is TX,the lower is RX antenna.
UHF+VHF
SMA,antenna
Modem select: STM32_HS_GPIO
Set TX frequency,RX frequency
TX,RX frequency had better 10M or more apart.
SLOT1,SLOT2 support.
Specifications:
Color: Black/Transparent
Material: PCB+Acrylic
Size: 65*75*20mm
?
Note:?
- The firmware is pre-loaded. Please do not upgrade the firmware by yourself.
Package Included: (Fully assembled and tested Jumbo-Spot-RTQ)
1x3.2 LCD?display?
1xRaspberry pi 0(zero)
1xMMDVM HotSPOT Module
1x8G TFT card?
1xCase?
2x433Mhz antenna?
?
