This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1848
New 5v-12v Dc Brushless Driver Board Controller for Hard Drive Motor
New
R394.00
Closed
22 May 24 15:13
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613422218
The driver board can drive hard disk brushless motors, CD-ROM brushless motor and so on, the micro-type 3-wire or 4-wire without hall brushless motorIt's have reverse voltage protection , Over current protection, Phase inversion controlDriver voltage : DC5-12vWorking voltage : 1.2ASpeed adjust :0%-100%Note : Brushless motor line of receiving terminal drive plate must be pressed sturdiness, poor contact will lack of phase operation and burn out the chip.Board terminals fixed screw clearance, please use coarser line connected to the board.How to identify four line motor public port: use the resistance of the multimeter * gears test this four terminal,One of the terminals and the other three terminal resistance value of the minimum and equal. So it's COM terminalSize:6 x 4.5cm/2.36inch x 1.77inchcolor:As shownMaterial:PC+MetalPackage Contents:1 x Motor Drive BoardOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.