Radiolink R12DS 2.4G 12CH FHSS DSSS Spread Spectrum Dual Antenna Receiver
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615154065
Working Mode:
1.PWM signal output working mode : red LED indicates PWM signal output, 11 channels Totally.
2.S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.
S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).
PWM signal working mode:
S-BUS signal working mode:
Description:
Brand Name: Radiolink
Item Name: R12DS 2.4G 12CH Dual Antenna Receiver
Channels: 12 channels,output 12 channels signal, support S-BUS and PWM signal output synchronously.
Working voltage: 4.8-10V
Working current: 38-45mA ( input voltage: 5V)
Size: 50*31.5*14.5 MM
Weight: 14g
Receiver integrate telemetry sensor including signal strength and voltage. Support extended engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, Speed, voltage etc. on AT9/AT9S/AT10/AT10II display when work with flight controller APM or PIX.
Resolution: 4096 section precision, 0.25us per section, servo anti-shake rudder.
Control distance: about 4 kilometers air(Maximum range tested in unobstructed areas free of interference and may vary depending on local regulations).
Note:
1.Put the transmitter and the receiver close to each other within 1 meters.
2.Turn on the transmitter, then power on the R12DS.
3.Connect CH3 of R12DS to ESC.
4.There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on!
Instroduction:
Package Included:
1X Radiolink R12DS 2.4G 12CH Dual Antenna Receiver
1.PWM signal output working mode : red LED indicates PWM signal output, 11 channels Totally.
2.S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.
S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).
PWM signal working mode:
S-BUS signal working mode:
Description:
Brand Name: Radiolink
Item Name: R12DS 2.4G 12CH Dual Antenna Receiver
Channels: 12 channels,output 12 channels signal, support S-BUS and PWM signal output synchronously.
Working voltage: 4.8-10V
Working current: 38-45mA ( input voltage: 5V)
Size: 50*31.5*14.5 MM
Weight: 14g
Receiver integrate telemetry sensor including signal strength and voltage. Support extended engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, Speed, voltage etc. on AT9/AT9S/AT10/AT10II display when work with flight controller APM or PIX.
Resolution: 4096 section precision, 0.25us per section, servo anti-shake rudder.
Control distance: about 4 kilometers air(Maximum range tested in unobstructed areas free of interference and may vary depending on local regulations).
Note:
1.Put the transmitter and the receiver close to each other within 1 meters.
2.Turn on the transmitter, then power on the R12DS.
3.Connect CH3 of R12DS to ESC.
4.There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on!
Instroduction:
Package Included:
1X Radiolink R12DS 2.4G 12CH Dual Antenna Receiver