This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1770
Crank Arm Removal Tool Suitable for Cannondale Si Kt013
New
R632.00
Closed
22 May 24 15:28
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613481589
100% Band new and high quality.Easy to install, reliable quality that guarantees stable and excellent performance.Do not blindly replace the bottom bracket bearing when there is abnormal noise on the bottom bracket. Normally, you only need to remove the chainring and crank, and perform a careful maintenance. Add a BB30 gasket (not included) for better protection and use. product.Made of stainless steel, T6 heat treatment, higher strength and longer service life. The crank tool is extruded statically, which does not damage the crank axis.Crank tool: thimble length 41mm, thread diameter 18mm, top block length 18.5mm, thread diameter 22mm.Specifications:Crank tool:thimble length:41mm thread diameter 18mmTop block length: 18.5MM thread diameter 22MMweight:88gColour:silverMaterial:Stainless steelPackage Contents:1 * crank toolOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.