***LOCAL STOCK*** WiFi OBD OBD2 Diagnostic Interface For PC iPhone iPad iPod

This OBD is able to detect and interpret the above mentioned protocols automatically. It also supports high speed communications and low power sleep mode. It uses AT commands to communicate with a host device (PC, notebook, iPhone, iPod touch, iPad and so on). There are plenty of software packages available, which are fully compatible with this device.

Generally, it is compatible with 1996 and later vehicles, but due to some unknown updated protocols, we only insure it can work on all 1996 to 2010 cars and light trucks.

When you have this device on hand, just connect it to your iPhone/ iPod touch is made by WIFI connection in adHoc mode. With proper software installed in the host device, you may have following parameters read out fromyour vehicle:

-Vehicle Speed

-RPM

-Fuel Consumption

-Engine Coolant Temp

-Fuel Pressure

-Calculated Engine Load

-Throttle Position

-Intake Manifold Pressure

-Air Intake Temp

-Timing Advance

-Mass Air Flow

-Fuel Level

-Barometric Pressure

-EVAP System Vapor Pressure

-Fuel Trim

WIFI OBD2 Specification

1. OBD-II Protocols

ISO15765-4 (CAN) ; ISO14230-4 (KWP2000) ; ISO9141-2 ; J1850 VPW ; J1850 PWM

2. Output protocol

RS232

Baud rate:9600 or 38400

Indicator LEDs:OBD Tx/Rx, RS232 Tx/Rx, Power

Operating voltage:12V, internal protection from short circuits/overvoltages

Nominal idle current:45 mA

For specific compatibility information please check your vehicle's user guide or with the manufacturer. Please do bear in mind that while we do our very best to provide accurate information we cannot be held responsible in the unlikely event that this code reader does not work with a certain car or van.

Package Including:

1pc x ELM327 WIFI OBD2 Scanner

1pc x CD Driver