__TINY FM SPY BUG. Fits on your thumb tip. _ CIA Quality!!

New

2 were available

R350.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Albatross Wholesale7906

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Bob Shop ID

19529349

Transmit sounds picked up from a room to any ordinary FM radio up to 100m!!

CIA Quality.

You can even pick up the FM signal from this tiny bug on you Cell Phone If it has a built in radio function.

TINY SPY BUG
With 2 FREE batteries!!

We are giving you 2 free batteries to use with this transmitter . Each battery should give you around 40 hours of use!

This IS the only SPY bug available on Bid or Buy measuring just 22mm diameter (29.5mm for the protruding microphone and rear) x only 11mm thick and

THIS IS WITH A BATTERY INSTALLED!!!

This tiny transmitter runs off a tiny coin cell and the measurements given above include the cell holder!

The bug can tune to the whole of the FM broadcast band 88-108MHz as well as a little above and below! All that is required to tune this is a small flat blade screwdriver - turn the small screw and you can tune it to where ever you like!

The quality small electric microphone will pick up the smallest of sounds and transmit them to your radio with crystal clear reproduction.

Only quality surface mount components have been used on a professionaly designed circuit board. The copper of the board has been coated to prevent corrosion -

The bug is tested before being sent!

See some of my other great gadgets below.